I am searching documents that are built into sections and would like to search the last section only until the end of the record. How do I construct the search parameters since there is not a consistent end of record identifier. Would I use something like:
I tried it and I don't seem to get reliable results. Sometimes I'll get documents where the word is found in the preceeding section rather than the section I am interested in. Is is as if when Texis gets to the end of the record without finding the word it starts searching through the document from the bottom up.
Here is the quesry: where $field like 'sensor w/\RCLMS\n w/\P.=>>='
Here is a sample of the result section. "Sensor" is only found in the sections before this:
CLMS
STM What is claimed is:
NUM 1.
PAR 1. An annular member forming method of forming an annular workpiece which
is pressed between a forming roll and a mandrel moved towards and away
from each other by a moving device, comprising the steps of:
PA1 (a) rough rolling the annular workpiece at a first moving speed of moving
the forming roll and the mandrel towards each other;
PA1 (b) moving backwardly the moving device away from the mandrel by a
predetermined distance; and
PA1 (c) finish rolling the annular workpiece at a second moving speed which is
lower than the first moving speed; and
PA2 wherein the predetermined distance corresponds to a difference between an
amount of elongation which is due to a first rolling load during the step
(a) and an amount of elongation which is due to a second rolling load
during the step (c).
NUM 2.
PAR 2. The annular member forming method of claim 1, wherein a rolling load
acting on the annular workpiece is decreased as much as an amount of
retraction corresponding to the difference in the step (c).
NUM 3.
PAR 3. A method of forming an annular member comprising the steps of:
PA1 providing a rotatable forming roll in contact with an outer cylindrical
surface of an annular workpiece;
PA1 providing a mandrel movable relatively towards and away from the forming
roll and confronting the forming roll in contact with an inner cylindrical
surface of the annular workpiece;
PA1 providing outside diameter detecting device for detecting an outside
diameter of the annular workpiece which is to be worked;
PA1 relatively moving the forming roll and the mandrel in a closing direction
to sandwich the annular workpiece between the forming roll and the mandrel
to subject the annular workpiece to rough rolling and to finishing
rolling; and
PA1 controlling the relative movement of the forming roll and the mandrel so
that the moving device relatively moves the forming roll and the mandrel
in a separating direction opposite to the closing direction by a
predetermined distance during the change from the rough rolling to the
finishing rolling, and
PA1 wherein said predetermined distance is substantially equal to a difference
between an elastic deformation of the annular member forming apparatus
occurring in the rough rolling and an elastic deformation of the annular
member forming apparatus occurring in the finishing rolling.
